Aquarium Gravel Vacuum How To Use
Don t siphon the top of the water the majority of the waste is on the bottom.
Aquarium gravel vacuum how to use. Hold it straight and let the liquid fill inside it slowly. How does an aquarium gravel vacuum work. By pulling up and down on the tube waste particles are freed and will get sucked up by the aquarium gravel cleaner.
Repeat step four until you have cleaned about 1 3 of the gravel. If you are looking for a quick start method for your aquarium gravel machine simply submerge the vacuum head in your tank and suck on the end of the plastic hose until the water begins to flow through it. Stick the rigid tube into the substrate and allow a few seconds for the sand gravel rocks to be pulled into the tube.
This will allow the gravel to drop back out. A gravel vacuum operates by churning the gravel around in a column of moving water to loosen and carry off any debris trapped in the gravel. Start the siphon process and plunge the aquarium gravel cleaner into the gravel.
Once your siphon is started vacuuming is a simple process. Once you have this setup you re ready to start. The power to operate your gravel vacuum typically comes from a siphon.
Do it thrice and all of the bubbles will remove and your equipment will be ready to use. Immediately swear as gravel goes all the way up your vacuum tube and clogs it up. Bend your hose 90 degrees like a kink in a water hose to slow the flow.
Before the water reaches your mouth place the end of the hose in the bucket and begin to vacuum the gravel as you normally would. The most common practice is to use a plastic bucket on the floor next to the aquarium but you can also get setups that connect the hose to your sink for really easy drainage. Just place your hose or gravel vacuum into the aquarium squeeze the bulb on the other end and water will begin flowing through your hose and out of your tank.